Multi-modal imaging for dynamic visualization of osteogenesis and implant degradation in 3D bioprinted scaffolds. Bioactive materials monitoring of bone regeneration enables timely diagnosis and intervention by acquiring vital biological parameters. However, an existing gap exists in the availability of effective methodologies for continuous and dynamic monitoring of the bone tissue regeneration process, encompassing the concurrent visualization of bone formation and implant degradation. Here, we present an integrated scaffold designed to facilitate real-time monitoring of both bone formation and implant degradation during the repair of bone defects. Laponite (Lap), CyP-loaded mesoporous silica (CyP@MSNs) and ultrasmall superparamagnetic iron oxide nanoparticles (USPIO@SiO) were incorporated into a bioink containing bone marrow mesenchymal stem cells (BMSCs) to fabricate functional scaffolds denoted as C@M/GLU using 3D bioprinting technology. In both and experiments, the composite scaffold has demonstrated a significant enhancement of bone regeneration through the controlled release of silicon (Si) and magnesium (Mg) ions. Employing near-infrared fluorescence (NIR-FL) imaging, the composite scaffold facilitates the monitoring of alkaline phosphate (ALP) expression, providing an accurate reflection of the scaffold's initial osteogenic activity. Meanwhile, the degradation of scaffolds was monitored by tracking the changes in the magnetic resonance (MR) signals at various time points. These findings indicate that the designed scaffold holds potential as an bone implant for combined visualization of osteogenesis and implant degradation throughout the bone repair process. 10.1016/j.bioactmat.2024.03.022

Biodegradable WE43 Mg alloy/hydroxyapatite interpenetrating phase composites with reduced hydrogen evolution. Bioactive materials Biodegradable magnesium implants offer a solution for bone repair without the need for implant removal. However, concerns persist regarding peri-implant gas accumulation, which has limited their widespread clinical acceptance. Consequently, there is a need to minimise the mass of magnesium to reduce the total volume of gas generated around the implants. Incorporating porosity is a direct approach to reducing the mass of the implants, but it also decreases the strength and degradation resistance. This study demonstrates that the infiltration of a calcium phosphate cement into an additively manufactured WE43 Mg alloy scaffold with 75 % porosity, followed by hydrothermal treatment, yields biodegradable magnesium/hydroxyapatite interpenetrating phase composites that generate an order of magnitude less hydrogen gas during degradation than WE43 scaffolds. The enhanced degradation resistance results from magnesium passivation, allowing osteoblast proliferation in indirect contact with composites. Additionally, the composites exhibit a compressive strength 1.8 times greater than that of the scaffolds, falling within the upper range of the compressive strength of cancellous bone. These results emphasise the potential of the new biodegradable interpenetrating phase composites for the fabrication of temporary osteosynthesis devices. Optimizing cement hardening and magnesium passivation during hydrothermal processing is crucial for achieving both high compressive strength and low degradation rate. 10.1016/j.bioactmat.2024.08.048